公司简介企业荣誉组织架构
   您当前的位置:首页 | 关于乐虎娱乐唯一官网 | 公司简介
   
压铸模具技术要求
•; GATE: external direct (opposite side of the hinge). Flow direction should climb over the gasket side.
•; EJECTION: ejector pins (ø; 10 mm) on bosses connected to the wall by a rib (thickness= 3 mm max) and other ejector pins on the bottom in bas-relief.
•; SLIDES: no slides are necessary.
•; MOULD PARTING: use the plane passing through cylinder axis and through the center of lateral appendage.
•; GATE: on the side of cylinder (opposite side of appendage).
•; SLIDES: nr. 2 horizontal slides:
1. For cylindric internal part,
2. For appendage internal part and for cylinder upper face (to the end of the radius).

•; GATE: external direct (opposite side of the hinge). Flow direction should climb over the gasket side.
浇口:外部方向(铰链对面)。流向须爬过衬垫侧。
•; EJECTION: ejector pins (ø; 10 mm) on bosses connected to the wall by a rib (thickness= 3 mm max) and other ejector pins on the bottom in bas-relief.
浇铸:通过筋板(最大厚度= 3 mm)连接到墙板上的模板上的顶杆(ø; 10 mm)和在型腔底部上的其他顶杆。
•; SLIDES: no slides are necessary.
滑块:不需要。
•; MOULD PARTING: use the plane passing through cylinder axis and through the center of lateral appendage.
模具分型面:利用通过圆柱轴线和侧面附加件的中心的平面
•; GATE: on the side of cylinder (opposite side of appendage).
浇口:圆柱的侧面(附件的对面)
•; SLIDES: nr. 2 horizontal slides:
滑块:2号水平滑块
1. For cylindric internal part,
圆柱内部件
2. For appendage internal part and for cylinder upper face (to the end of the radius).
附件内部件和圆柱顶面(到圆弧的端部)
返回首页 关于乐虎娱乐唯一官网 新品展示 人才资源 联系方式 ENGLISH  
Copyright 2008-2010 福州乐虎娱乐唯一官网乐虎国际娱乐168械有限公司.版权所有.All Right Reserved.
<友情连结> 无锡高特迈乐虎国际娱乐168械制造有限公司/ 南宁SEO网站优化推广/ 青岛海德马克智能装备有限公司/ 留澳网澳大利亚中文门户网站/