<友情连结> 无锡高特迈乐虎国际娱乐168械制造有限公司/ 南宁SEO网站优化推广/ 青岛海德马克智能装备有限公司/ 留澳网澳大利亚中文门户网站/
COMPANYHONNORORGANIZATION
   Position:Home | Trends
   
GATE: external direct
•; GATE: external direct (opposite side of the hinge). Flow direction should climb over the gasket side.
•; EJECTION: ejector pins (ø; 10 mm) on bosses connected to the wall by a rib (thickness= 3 mm max) and other ejector pins on the bottom in bas-relief.
•; SLIDES: no slides are necessary.
•; MOULD PARTING: use the plane passing through cylinder axis and through the center of lateral appendage.
•; GATE: on the side of cylinder (opposite side of appendage).
•; SLIDES: nr. 2 horizontal slides:
1. For cylindric internal part,
2. For appendage internal part and for cylinder upper face (to the end of the radius).

•; GATE: external direct (opposite side of the hinge). Flow direction should climb over the gasket side.
浇口:外部方向(铰链对面)。流向须爬过衬垫侧。
•; EJECTION: ejector pins (ø; 10 mm) on bosses connected to the wall by a rib (thickness= 3 mm max) and other ejector pins on the bottom in bas-relief.
浇铸:通过筋板(最大厚度= 3 mm)连接到墙板上的模板上的顶杆(ø; 10 mm)和在型腔底部上的其他顶杆。
•; SLIDES: no slides are necessary.
滑块:不需要。
•; MOULD PARTING: use the plane passing through cylinder axis and through the center of lateral appendage.
模具分型面:利用通过圆柱轴线和侧面附加件的中心的平面
•; GATE: on the side of cylinder (opposite side of appendage).
浇口:圆柱的侧面(附件的对面)
•; SLIDES: nr. 2 horizontal slides:
滑块:2号水平滑块
1. For cylindric internal part,
圆柱内部件
2. For appendage internal part and for cylinder upper face (to the end of the radius).
附件内部件和圆柱顶面(到圆弧的端部)
PYRIGHT @ Fujian Fuzhou Chengchang Machinery Co,.Ltd ALL RIGHTS RESERVED
WEBSITE:www.fzcc.com.cn
 
<友情连结> 无锡高特迈乐虎国际娱乐168械制造有限公司/ 南宁SEO网站优化推广/ 青岛海德马克智能装备有限公司/ 留澳网澳大利亚中文门户网站/